Community Mold Project Round 5

	These are the pieces contributed by Kovax for the round. A 4" round tower arch and side piece as well as a bag. These are some very nice pieces.
These are a couple of crates and a barrel I made awhile back. I intended to submit them for round 4 but they weren't ready in time.
	Some extra sloping pieces like the one on the Fieldstone accessory mold. I needed a bunch of these and didn't want to use just one piece for them all so I made some different patterns. I'm very happy with two of them. The other two are ok but I probably won't use them much.
Some extra stair pieces similar to the one off the Fieldstone Bridge mold. I was making a large staircase and was concerned with the pattern getting repetitive and these were the result.
	A fieldstone T piece to break the horizontal lines in a fieldstone structure. It's 1" long at the top and the bottom is 1/2" wide. This works especially well with the 1.5" fieldstone piece (or a 1/2" fieldstone piece) so the walls come out even.
Speaking of a 1.5" fieldstone piece, here's mine. Kovax did a good job on his 1.5" fieldstone piece but I wanted a different pattern so it wouldn't end up being repetitive when I used it a lot.